Test terminal blocks are applied in measurement and control equipments to realize all connections of secondary circuits in current transformer. The sliding plate with captive slide nut is provided between the two connection screws, high short current withstand, its advantages : save space, few accessories needed, easily installed, switching circuit is clearly legible.

SKJ-4/2-2 terminal can save space, from side view this terminal half terminal thickness is staggered between upper and downside layers of wiring positions, this layout is very useful due upper and downside layer shall be connected with cable.

Order No.			01018
Dimensions
Width x Length x Height		(mm)	72/8.2/51
Nominal screw diameter		(mm)	M4
Torque		(Nm)	1.5-1.8
Stripping Length		(mm)	13
Parameter
Voltage Rating		(V)	800
Current Rating		(A)	57
Wire section		(mm²)	6
Wire Range
Rigidity wire range		(mm²)	0.5-10
Soft wire range		(mm²)	0.5-6
DIN Rails			Type	Order No.
Mountable rail type			G32-15L G32-18/15	02006 02007
			TH35-7.5	02005
End clapboard
			SKJ-6SG	01036
Clapboard
Used for electric isolation between adjacent jumpers. After that, insert it.
Grouping clapboard
For the terminal group of visual and electrical isolation
Internal Jupmer
Used for transversely bridge conn- ected in the center of terminal block, according to actual operation the voltage can be distributed.	10 pole		SFBI 10-RTK/S	01049
	3 pole		SFBI 2-RTK/S	01050
	2 pole
External Jumper
2 pole			SEB 2-8	01059
3 pole			SEB 3-8	01063
10 pole			SEB 10-8	01053
Mark Tag
Blank			SZB8-10	01067
10 no. Horz.			SZB8 (Horizontal)
10 no. Vert.			SZB8 (Vertical)